Making miniature 1/12th scale fruit crates

GCoderCNC 2.5D banner

Sometimes it seems like there’s no end to the range of projects we can make with a CNC machine. And it’s quite amazing that even cheap versions are accurate enough to make miniature projects for model scenery and even dolls houses. So I thought it might be fun to try making some miniature fruit crates, as the photo above shows, and post the design here for anyone to have a go at making some too. At full size they would be around 450mm long, 300mm wide and about 200mm high but at 1/12th scale, commonly used for dolls houses, they’re much smaller: I’ve included a photo below with a one pound coin for comparison.

A photo of the miniature fruit crates with a one pound coin for scale

I’ve put an SVG file below for you to download, or you can click here to launch it in the GCoderCNC web-app. If you need to edit it, or make a DXF file for your CNC software, you can do that with Inkscape quite easily. The red box is there in case you need to get scale in your software, but doesn’t need to be cut: it should be 70mm wide by 65mm high for 1.5mm thick wood (or other materials such as plastic, or even cardboard, if you prefer). If you use thicker material you can scale it proportionately, such as 2x scale for 3mm thickness. The design works for LASER cutting but can be adjusted easily for routing by offsetting the lines through half the cutting width.The SVG file of the fruit crates for cutting or editing in InkscapeI LASER-cut a prototype in Oak (the one on top in the photo above) and the rest in Basswood, both from 1.5mm sheets. Once cut they are quite simple to put together. I started by putting the sides onto the bottom of the crate, then slipped the ends on one at a time. I also used glue at all the push-in joints: the base could be left floating but the glue helps prevent the thin pieces of wood at the joints breaking away when sanding. To finish the crates off I used 400 and 1000 grit sandpaper, including using a finger sander, followed by a couple of coats of Danish Oil to give the wood a nice look without too much of a shine. Personally I’m quite happy with the results and hopefully you’ll enjoy making some on your CNC machine too 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *