Clip for 20mm extruded section frame

20mm square extruded aluminium section is commonly used for cheap CNC routers, especially for kit versions. So I designed this very simple 3D printed part that clips over three edges of the section. I did that for two reasons, the first being that I wanted to use one with two of my frame-end feet 3D prints (click here to read more) to make a stable tri-point support to reduce vibrations when routing. Secondly though, it’s just a useful thing to have to glue to anything I want to fix onto the frame while still being able to remove it later (e.g. bit holders or cable tie down pads). If you’d like to 3D print your own, just click here to get the STL files on Thingiverse.

A 3D model of the frame clip

Tagged : / / / / / / /

Support foot for 20mm extruded section

Many cheap CNC routers are based on 20mm square extruded aluminium frames, with slots and a hole running along them to attach fixtures. Often the four pieces of the frame at the bottom lie directly on the underlying surface, with no supports at the corners. That can be a problem as routing can cause a fair bit of vibration that can be transmitted straight into your work surface. If left unchecked, that can lead to annoying noise as the work surface and adjoined walls and floors vibrate with it. So, I designed this simple foot that can be slotted into the end of a 20mm extrusion that lifts it off the surface below, and which you can also use to add a small rubber or felt pad, further reducing noise and vibration. To get the STL files for 3D printing just click here.

A 3D model image of the foot

Tagged : / / / / / /